Specification for laying hdpe geocells on roadbeds
Before laying, the base should be thoroughly leveled and reinforced. Then use a hammer to strike and wet all the moisture on the base layer. Arrange the mesh cloth with the surface facing the road, and the edges of the mesh cloth must not move.

2. Disperse the geocells on the grid cloth, with the direction perpendicular to the centerline of the road, and divide the points into sections according to density.

3. Connect the interfaces correctly, and you should press the grid at the height of 2 units at the joint.

4. Each layer of hdpe geocell should be prepared and laid according to the design requirements to avoid affecting the use effect due to poor laying quality, misalignment, deformation, and other reasons.

5. After laying, it should be filled and compacted in a timely manner to ensure that the physical properties of the level where the compartment is located meet the design standards, and to ensure that the laying of the upper subgrade is carried out as soon as possible after filling, compaction or setting up the grate.